Polyblend grout how much water

During slaking, moisture fully permeates all the powder; without proper slaking, grout will be weaker and more prone to cracking and chipping. Mix your batch of grout thoroughly one more time, and get busy applying it to complete your DIY tile job.

Add the powder to the water, tilt your work bucket at a degree angle and use a grout-mixing knife or trowel to mix the two together. Let the grout rest for five or 10 minutes, and mix again. Wait 15 to 20 minutes before wiping off excess grout.

If you wipe it too soon, you will pull too much out of the joints. If you wait too long, it becomes difficult to remove. Wet grout, when it finally dries, may shrink and crack. Consider using an additive if it makes sense for your project.

Disclosure: BobVila. You agree that BobVila. All rights reserved. Expert advice from Bob Vila, the most trusted name in home improvement, home remodeling, home repair, and DIY.

More From Bob Vila. How To: Mix Concrete. Newsletter signup: You agree that BobVila. How do you remove old grout? Make an incision down the middle of each grout line using a grout saw, preferably one with a carbide blade.

Remove the grout. Remove the grout from between the pieces of tile with a grout scraper, using the incision as a starting point. Finish the edges. Can you mix grout by hand? Mix the grout until it's powder-free Scrape the bottom to make sure all the grout is mixed. Pour some grout out of the bag into a mixing bucket. And don't mix grout with a drill and mixing paddle. How can I thicken my grout? Too Much Water in Grout This is called slaking and will assist in not adding too much water or mix as you go.

If you have too much water in the grout, the mix will be runny and will clump as it pours off the float. Add a small amount of latex additive into the mix. The sticky substance adds creaminess to the mixture. What can I use instead of a grout float? Grout Bag Alternative An alternative to the float is a grout bag.

Think of it as a pastry bag but for use with grout instead of frosting. If you're looking for grout application tips for porous or uneven tiles, this may be your solution. To use, fill the bag with the prepared grout. Shoot for thick milkshake consistancy. Oh and one more thing, begin with no more that 20 sq ft at a time until you get the hang of it. You don't want clean-up to get away from you.

Thanks, Mike and Jeff. I'm going to mix up a very small amount tonight to test the caulk and grout colors. I'll put a pic up on my big thread.